First team nitro install 99pct completed

I started at 6am this morning. Basically it is all done except I need to install the top cap, height marker  and I want the padding to “relax” before Icomplete fitting it. I have a completed picture except tools are still scattered about. I left a note for my son to clean up because i had to get to work. Tonight I will post fresh pics of what the whole install looks like.

It all went very smoothly exactly according to the instructions except in retrospect I learned the following:

1) If you are going to pour cenet, move all of your components VERY far away from the pour. it splashes a lot and got on my components. I washed them off but there are still residual traces.

2) I was able to mount the glass backboard “myself:” as long as my wife pushed and stabilized from underneath.

3) When mounting the glass on the frame, keep the bolts lose. The holes in the glass are protected by silicone gaskets that move around and potentially occlude the hole. It is easier to adjust if the glass is slightly lose ( although secure ! ) and tighten completely AFTER the goal is installed.

4) to put the goal up, start with ONE screw in the top slot. secure with washer, lock washer and nut. Go get the next set and then secure the other top slot ( instructions say to install both bolts in goal before lifting to mount. my way is better).

5) I almost put the top cap on the post before i lifted it into place but i was sure there must be a reason that the instructions called for it last when it was obviously going to be so much more difficult. I figured I was going to need to get my hand in there for a step that was not obvious to me. Actually – NO ! Put the top cap on BEFORE you lift the post. It would have been way easier.

Leave a Reply